Here are some tips in order to make sure that air compressor is always up and running:
Read the manual. The worst thing you can do as the owner of the air compressor is to neglect the manual and not read it. Reading it will not only give you the detailed instruction on how to get the compressor to work but the manual will also be loaded with tips on how to care for the equipment and every part of it. Unless you take some time to read it, you will never know that some of the maintenance tips that you have to do are very simple and would require very minimal technical knowledge. There are also rules stated in the manual that you should follow in order to avoid inflicting damage on the equipment and voiding your warranty in the process.
Tight fasteners. Whenever the air compressor is turned on, the whole equipment is running and vibrating at the same time. It is not unlikely that some of the screws as well as the nuts and bolts inside will loosen more frequently than you have expected. Make sure that these are checked daily and remember to tighten anything that you feel has loosen up in the process.
Release the moisture. Whenever the compressor is operating, the receiver tank has an accumulated moisture as a result of the process. This is worse for those who are residing in countries where the climate is very humid. For many of the air compressors, there is a built in valve that can be used in order to release the moisture out of the tank. The only thing you have to do is to remember to drain it on a daily basis. Keep this in mind to avoid sending your air compressor repair Toronto.
Daily hose inspection. The hose is one of the most important part of the compressor because it serves as the medium. With daily use and operation, the hose may be cracked or experience some wear which could affect the entire system. It should be replaced immediately.
Clean the vents. Whenever your air compressor is forced to operate more than the system could take, the compression power could lessen. As a result, the lifespan and efficiency of the equipment may be affected. To make sure this does not happen, always the clean the intake vent regularly with daily checkup to make sure they are not dirty or full of dust.