The first thing that you have to do when using the adhesive accelerator is to test it. This can be done on a small portion on the bonding surface. There are some types of surfaces that are not compatible with accelerators. They will end up reacting or corroding when you apply this chemical. You can avoid this by testing on a small portion of the surface. If you find that the surface is compatible with the accelerator then you can continue with the process comfortably. You need to clean both surfaces carefully and thoroughly using the best detergent before you apply the adhesive. The application of the adhesive accelerator will be done once you have clamped the surface together or before you create the bond. If you want to apply the accelerator after bonding you should apply it on the opposite surface on which the adhesive has been applied. Post application is usually done when you want to make a few adjustments before the bond is completely formed. On the other hand, pre-application is used to make slow-curing adhesives cure much faster. Always ensure that you do not apply excess adhesive since it will make the entire work messy.